Upaya Meminimalisir Tingkat Cacat Proses Produksi Pada Fabrikasi Pipe Support MSP – Triraya Menggunakan Metode Fishbone Diagram  Dan 5w + 1H

Sajidah Tiara Ayu Wiranda; Iriani Iriani

doi:10.61132/venus.v2i1.82

Authors

Sajidah Tiara Ayu Wiranda Universitas Pembangunan Nasional “Veteran” Jawa Timur
Iriani Iriani Universitas Pembangunan Nasional “Veteran” Jawa Timur

DOI:

https://doi.org/10.61132/venus.v2i1.82

Keywords:

Cause-Effect Diagram, Defects, Scratch, 5W + 1H Method.

Abstract

Quality is an important factor in production, so companies must maintain the quality of their products in order to be able to compete in the market. One of them is PT. Swadaya Graha operates in the construction and fabrication services sector, working on several projects, one of which is pipe support. In pipe support fabrication there are problems during the production process. This problem is the presence of "scratch" defects on the surface of the material. The aim of the observations carried out is to minimize the occurrence of production process defects in pipe support fabrication. From the results of the analysis using a cause-and-effect diagram, there are 3 factors that cause defects. And improvement efforts to minimize defects using the 5W + 1H method.

Keywords: Cause-Effect Diagram, Defects, Scratch, 5W + 1H Method.

References

Dewi, A. A. & Yuamita, F. (2022). Pengendalian Kualitas Pada Produksi Air Minum Dalam Kemasan Botol 330 Ml Menggunakan Metode Failure Mode Effect Analysis (FMEA) Di PDAM Tirta Sembada. Jurnal Teknologi dan Manajemen Industri Terapan. Vol 1. No. 1.

Ginting, E. F., Ibnutama, K., & Suryanata, M. G. (2019). Implementasi DES (Data Encryption Standard) Untuk Penyandian Data Bill Of Material pada Divisi Produksi PT.Siantar Top, Tbk. Sains dan Komputer (SAINTIKOM). Vol 18. No. 2.

Julian, F., Kardiman, & Fauji, N. (2022). Sistem Pengendalian Kualitas (Quality Control) Pada Proses Fabrikasi Project “Refinery Development Master Plan (RDMP)’’. Junral Ilmiah Wahana Pendidikan. Vol. 8. No. 15.

Krisnaningsih, E. & Hadi, F. (2020). Strategi Mengurangi Produk Cacat Pada Pengecatan Boiler Steel Structure Dengan Metode Six Sigma Di PT. Cigading Habeam Center. Jurnal InTent. Vol. 3. No. 1.

Tampai, Y. S., Sumarauw, J. S. B., & Pondang, J. J. (2018). Pelaksanaan Quality Control Pada Produksi Air Bersih Di PT. Air Manado. Jurnal EMBA. Vol. 5. No. 2.

Wirdasih, N. W., Ridlwan, H. M., & Wibowo, H. (2019). Optimasi Pengurangan Outstanding Purchase Order dengan Sistem Notifikasi Otomatis. Prosiding Seminar Nasional Teknik Mesin Politeknik Negeri Jakarta. Vol. 19. No. 26.